WATER LEVEL CONTROLLER TO SWITCH ON AND OFF THE MOTOR AUTOMATICALLY FOR EITHER SUCTION OR DELIVERY TANK
In suction tank motor switches off automatically when water level goes below the set lower probe and switches on automatically when water reaches the set probe of the above level.
In the case of delivery tank the motor automatically starts when the water level reaches below the set level and automatically stops when the water reaches the higher level.
Water Level Controllor with starter provided with On/Off and Auto / Manual switch provided with 30 AMP. Relay for 0.5 to 1 H.P. Pumps to control two tanks suction and delivery. All other functions are the same as mentioned for POWERTEK Type MWL4 available with capacitor.
POWERTEK Water Level Controller functions same as WLC4 with 20 Amps. Relay to operate 0.5 to 1 H.P. Pump. When the switch is in the Manual mode the unit works like an ordinary starter. You can switch on by pressing green switch and switch off by pressing red switch.
Water Level Controllor to control suction and delivery tank. Functions- when the water level in the suction tank goes below the set level it switches off the motor automatically and when the water level reaches the set higher level it starts the pump automatically. At the same time if the water level in the delivery tank goes below the required the set point the pump starts automatically it fills up the tank to the higher level and switches off the motor automatically.
We at Powertek manufacture water level controllers, single phasing preventers, auto switches, timers, cyclic timers and control panels for single phase and three phase motors.We aim to facilitate and resolve any issues related to water management for different water levels in order to avoid wastage of water and electricity.
